Provides a more upright, comfortable riding position by raising your original 7/8" (22mm) diameter tubular handlebar. No need to replace your handlebars - simply remove the original top clamp, place the riser between the handlebar and original bottom clamp, and reinstall top clamp using included hardware.
No change of control cables, wiring, or hoses is required for the Vstrom using these 25mm handlebar risers, HOWEVER:
The installer should always check for adequate cable/wiring/hose slack after installing any handlebar riser!
Simply put, the amount of cable slack varies on factory bikes even within a single model and year, so while 99.9% of all bikes will not need adjustment of cables to install handlebar risers, you should ALWAYS check for adequate slack after installation.
This riser will fit your bike if:
(1) Your bar mounts are symmetrical and parallel
(2) Your bars are 7/8" outer diameter
(3) You have two M8 (8mm-diameter holes with standard M8 thread pitch) threaded holes in each of your two bar mounts
(4) The distance between the two holes in a single bar mount is 31-37mm on center. The distance between the two bar mounts is not a factor
20 mm height risers include four M8x55 screws and four M8x60 screws
25mm height risers include four M8x60 screws and four M8x65 screws
30mm height risers include four M8x65 screws and four M8x70 screws
50mm height risers include four M8x90 screws
|
